Use the coverage estimator to determine the proper amount of product to order. Remember to add for waste. Follow up orders are extremely difficult to match.

Allow 2-3 weeks lead time for your order, more time may be necessary for special order finishes or custom milled stock.

Do not store finished jobs for extended time periods after they are shipped, this leads to blocking.

Do not Stack other material on top of the bundle of pre-finished stock, the resulting blocking is beyond both our and the finisher’s control.

Refer to the WRCLA’s installation guide for application instructions. Be certain to 22.5 degree bevel all butt joints, coat the raw edges with matching stain, and then caulk the joints for a proper installation. Pay particular attention to the nailing patterns also, as improper nailing causes most of the problems customer’s encounter with cedar sidings.

Review stock quantities prior to installation guide for application instructions. Be certain to 22.5 degree bevel all butt joints, coat the raw edges with matching stain, and then caulk the joint for a proper installation. Pay particular attention to the nailing patterns also, as improper nailing causes most of the problems customer’s encounter with cedar siding.

Review stock quantities prior to installation so that should an additional order be necessary to complete a job, the job lots do not meet on the same side of the home. Matching different lots of wood and stain make achieving an exact match of the follow up order virtually impossible. As long as the matching is done one side of the project at a time, the variations are much less noticeable.

Semi-transparent stains do not offer any warranties.

No finishes carry a warranty against extractive bleeding.

Remember to order custom matched, hot dipped, galvanized split less siding nails and hammer caps.

Review the faxed order confirmation carefully before signing and returning to MAC.